Water goes straight onto the plaster; outworld built in. This page has the same steps as the printed card that comes with your order, so you can find them again any time.
Setting up
-
1Identify the parts
The nest is the plaster chambers where the ants live. Unlike most nests, it sits right inside the outworld, where they find food: both are built into the same piece. -
2Check the lid
Make sure the lid closes snugly; even a small gap lets ants out. Fluon, an anti-escape coating, is optional around the rim. -
3Water the plaster
Drip tap water onto the plaster with a pipette/syringe, away from the entrance. Wait about 5 minutes for it to soak in. Aim for partly dark, not soaked. -
4Move the colony in
Put the test tube in the built-in outworld at the nest entrance and cover the nest. Warm the nest portion (e.g. with a heat cable) so they move in faster. The nest is big enough once the colony would fill 1/5 of it; 1/3 is safer.
Living in your plaster nest
-
5Never let it dry out
Dark plaster is damp; pale is dry. Add a few drops before it turns fully pale. -
6Keep water off the brood
Never drip water onto ants or brood (eggs, larvae, pupae). Small ants can drown in one drop. -
7Add heat (optional)
A heat cable speeds up colony growth. Run it along one section of the side of the nest.
Good to know
- Water a little and often. Repeated soaking softens plaster.
- Feed in the built-in outworld, never the chambers.
- Adjust to your ants: crowding the warm side? Move the heat closer; the cool side, farther. Crowding the damp side? Add more water; the dry side, less.
Products this guide covers
Still need help? Contact us
Email: canada.ant.colony@gmail.com
Call/text: 778-268-4576 · Owner: 437-213-9082
Français : 514-512-2017 · 中文 Chinese: 647-962-9560
More guides: all product instructions · ant care sheets · ant-keeping guides




