Esthetic Ants Ytong Nests Instructions

← All product instructions

Aerated concrete nests with a water chimney. This page has the same steps as the printed card that comes with your order, so you can find them again any time.

Setting up

  1. 1
    Identify the parts
    The nest is the red or green plastic box with porous grey Ytong inside; this is where the ants live. The outworld (optional, sold separately) is a clear box where they find food.
  2. 2
    Unbox and check the chimney
    Peel the protective film off the cover. The chimney is the red/green tube you pour water into; if it popped off in shipping, lay the nest flat, chimney hole up, and press it back in. Leave all screws in.
  3. 3
    Water the nest
    Fill the chimney with tap water using a pipette/syringe. It takes several fills. The Ytong darkens as it gets wet: aim for partly dark, not soaked.
  4. 4
    Connect the outworld (optional)
    Two vinyl tubes come with this nest. Push the wider 12.7 mm tube into the outworld, slide the thinner 9.5 mm tube into it, then push the other end of the 9.5 mm tube into the nest port. Sizes vary slightly (metric vs imperial); seal a loose fit with hot glue or silicone. Plug unused holes with cotton.

Living in your Ytong nest

  1. 5
    Move the colony in
    Lay the test tube at the nest entrance and cover the nest with something dark. Warm the nest portion (e.g. with a heat cable) so they move in faster. The nest is big enough once the colony would fill 1/5 of it; 1/3 is safer.
  2. 6
    Never let it dry out
    Ants and brood (eggs, larvae, pupae) need humidity to survive. Refill the chimney before the Ytong turns pale; part of it should always look dark.
  3. 7
    Add heat (optional)
    A heat cable speeds up colony growth. Run it along one section of the side or top of the nest. The top is best: it keeps water droplets from forming on the acrylic.

Good to know

  • Adjust to your ants: crowding the warm side? Move the heat closer; the cool side, farther. Crowding the damp side? Add more water; the dry side, less.
  • Optional: brush Fluon (anti-escape coating) on the outworld rim.
  • Heavy fog on the acrylic means it's too wet. Skip a watering.
  • Feed in the outworld, never the nest: leftovers grow mould.

Products this guide covers

Small Ytong – Type BSmall Ytong – Type BTiny Ytong – Type ATiny Ytong – Type ASmall Ytong – Type ASmall Ytong – Type AMedium Ytong – Type AMedium Ytong – Type ALarge Ytong – Type ALarge Ytong – Type AExtra Large Ytong – Type AExtra Large Ytong – Type AMedium Ytong – Type BMedium Ytong – Type BLarge Ytong – Type BLarge Ytong – Type BExtra Large Ytong – Type BExtra Large Ytong – Type BRed Shield for Ytong NestsRed Shield for Ytong Nests

Still need help? Contact us

Email: canada.ant.colony@gmail.com
Call/text: 778-268-4576 · Owner: 437-213-9082
Français : 514-512-2017 · 中文 Chinese: 647-962-9560

More guides: all product instructions · ant care sheets · ant-keeping guides

← All product instructions

العودة إلى المدونة

تربية النمل مناسبة للجميع

إذا كنت مهتمًا بدعمنا، فتفقّد بعض مجموعات مزارع النمل لدينا!