Rock, Log and Stick nests. This page has the same steps as the printed card that comes with your order, so you can find them again any time.
MaterialClear acrylic
Tubing3/8" inside width (Stick nest: 1/4")
Setting up
-
1Assemble
Stack the acrylic layers in order and check the edges for gaps. Small ants escape through tiny gaps. -
2Plan for water
Acrylic doesn't hold water like plaster. Keep a water test tube or liquid feeder connected at all times. -
3Connect the outworld
The nest plugs straight into the small Buckeye outworld, a clear box where ants find food; it may need a firm push. With tubing, seal gaps with hot glue or silicone.
Living in your Buckeye nest
-
4Move the colony in
Lay the queen's test tube at the entrance and cover the nest with something dark. Warm the nest portion (e.g. with a heat cable) so they move in faster. -
5Keep it clean
Feed in the outworld, not the nest. If rubbish builds up, move the colony out, take the nest apart and hand wash it in hot water. -
6Add heat (optional)
A heat cable speeds up colony growth. Run it along one section of the side or top of the nest. The top is best: it keeps water droplets from forming on the acrylic.
Good to know
- Adjust to your ants: crowding the warm side? Move the heat closer; the cool side, farther.
- Rock and Log nests suit founding queens and small colonies. Stick nests suit twig-nesting ants like Temnothorax.
- Don't clean it with alcohol; it cracks acrylic.
- Fluon, an anti-escape coating, is optional. Let parts dry fully before reassembling.
Products this guide covers
Still need help? Contact us
Email: canada.ant.colony@gmail.com
Call/text: 778-268-4576 · Owner: 437-213-9082
Français : 514-512-2017 · 中文 Chinese: 647-962-9560
More guides: all product instructions · ant care sheets · ant-keeping guides


