Test Tube Outworld Instructions

← All product instructions

Feeding area for test tube colonies. This page has the same steps as the printed card that comes with your order, so you can find them again any time.

Size240 × 55 × 35 mm
Holds1–3 × 16 mm or 1–2 × 20 mm tubes

Setting up

  1. 1
    Fit the straw
    Cut a 2 cm piece of a plastic or paper drink straw and push it under the cotton at the tube mouth. It forms a tunnel: ants come and go, the tube stays humid and the outworld stays dry (see the diagram below).
  2. 2
    Seat the test tube
    Lay the tube in an indent, straw end facing the open area.
  3. 3
    Add heat
    This outworld works best warm. Run the heat cable along one side of the outworld only, so ants can move to the cooler end. Our cable is very hot.

Using your test tube outworld

  1. 4
    Feed and clean
    Feed away from the tube mouth; remove leftovers often.
  2. 5
    Swap tubes easily
    Water running low? Add a fresh tube; the colony moves over.
  3. 6
    Do NOT add water
    Keep the floor dry: damp hydrostone plus food waste grows mould.

How the straw keeps things dry

Outworld: keep DRY dry hydrostone floor food water wet cotton colony dry cotton plug 2 cm piece of drink straw under the cotton = tunnel

Good to know

  • Adjust to your ants: crowding the warm side? Move the heat closer; the cool side, farther.
  • Fluon (anti-escape coating) on the top walls is optional. Keep out of direct sun.

Products this guide covers

Test Tube OutworldTest Tube Outworld

Still need help? Contact us

Email: canada.ant.colony@gmail.com
Call/text: 778-268-4576 · Owner: 437-213-9082
Français : 514-512-2017 · 中文 Chinese: 647-962-9560

More guides: all product instructions · ant care sheets · ant-keeping guides

← All product instructions

ਬਲੌਗ ’ਤੇ ਵਾਪਸ ਜਾਓ

ਕੀੜੀਆਂ ਪਾਲਣਾ ਹਰ ਕਿਸੇ ਲਈ ਹੈ

ਜੇ ਤੁਸੀਂ ਸਾਡੀ ਮਦਦ ਕਰਨ ਵਿੱਚ ਦਿਲਚਸਪੀ ਰੱਖਦੇ ਹੋ, ਤਾਂ ਸਾਡੀਆਂ ਕੀੜੀਆਂ ਦੇ ਫਾਰਮ ਵਾਲੀਆਂ ਕਿੱਟਾਂ ਵੇਖੋ!