Clear acrylic outworld with an anti-escape ledge. This page has the same steps as the printed card that comes with your order, so you can find them again any time.
Size15 × 15 × 12 cm
Escape-proofHolds all species; no air vents to squeeze through
Setting up
-
1Unbox
Lift off the rim and lid. -
2Connect your nest
Push a 12.7 mm vinyl tube into one of the holes and run it to your nest. For nests with a 9.5 mm port (like Esthetic Ants), slide the thinner tube into the 12.7 mm one. Seal a loose fit with hot glue or silicone. -
3Plug unused holes
Close any unused hole with cotton or a plug so ants can't escape.
Using your Down The Ant Hill outworld
-
4Add substrate (optional)
A thin layer of sand or soil looks natural. To stop it shifting, set it with plaster of Paris or grout. -
5Add heat (optional)
Run a heat cable under one side, between the feet. Heating one side lets ants choose warm or cool. -
6Clean safely
Use only warm water and a soft cloth. Alcohol and solvents crack acrylic.
Good to know
- Adjust to your ants: are your ants crowding the warm side? Move the heat closer; the cool side, farther.
- Fluon, an anti-escape coating, is optional under the ledge.
- This is your ants' “above-ground” area. Feed here, not in the nest.
- Remove leftover food every day or two so it doesn't go mouldy.
Products this guide covers
Still need help? Contact us
Email: canada.ant.colony@gmail.com
Call/text: 778-268-4576 · Owner: 437-213-9082
Français : 514-512-2017 · 中文 Chinese: 647-962-9560
More guides: all product instructions · ant care sheets · ant-keeping guides
