Gentle warmth for faster colony growth. This page has the same steps as the printed card that comes with your order, so you can find them again any time.
Target25–27 °C for species that don't hibernate
Setting up
-
1Test it first
Plug it in alone for 10 minutes and carefully check the heat; it gets very hot. Never wrap it around a nest or tube. -
2Test tubes: tip only
Let the cable touch only the tip of the test tube. Heating the whole tube can cook the colony. -
3Nests: side or top
Run it along one section of the side or top. The top is best: it keeps water droplets from forming on the acrylic.
Using your heat cable safely
-
4Heat one end only
Leave the other end cool so ants can move away if it gets too hot. -
5Fix it in place
Tape the cable down so it can't slide under the setup. Don't let it cross over itself. -
6Turn it off for winter
Hibernating species need a cool winter rest: all Lasius, Formica and Crematogaster, and Camponotus (except C. castaneus, or Chestnut Carpenter Ants).
Good to know
- Adjust to your ants: crowding the warm side? Move the cable closer. Crowding the cool side, or moving brood away? Move it farther.
- Fog on the acrylic? Move the cable to the top.
- Check the setup daily for the first week.
Products this guide covers
Still need help? Contact us
Email: canada.ant.colony@gmail.com
Call/text: 778-268-4576 · Owner: 437-213-9082
Français : 514-512-2017 · 中文 Chinese: 647-962-9560
More guides: all product instructions · ant care sheets · ant-keeping guides
