Heat Cable Instructions

← All product instructions

Gentle warmth for faster colony growth. This page has the same steps as the printed card that comes with your order, so you can find them again any time.

Target25–27 °C for species that don't hibernate

Setting up

  1. 1
    Test it first
    Plug it in alone for 10 minutes and carefully check the heat; it gets very hot. Never wrap it around a nest or tube.
  2. 2
    Test tubes: tip only
    Let the cable touch only the tip of the test tube. Heating the whole tube can cook the colony.
  3. 3
    Nests: side or top
    Run it along one section of the side or top. The top is best: it keeps water droplets from forming on the acrylic.

Using your heat cable safely

  1. 4
    Heat one end only
    Leave the other end cool so ants can move away if it gets too hot.
  2. 5
    Fix it in place
    Tape the cable down so it can't slide under the setup. Don't let it cross over itself.
  3. 6
    Turn it off for winter
    Hibernating species need a cool winter rest: all Lasius, Formica and Crematogaster, and Camponotus (except C. castaneus, or Chestnut Carpenter Ants).

Good to know

  • Adjust to your ants: crowding the warm side? Move the cable closer. Crowding the cool side, or moving brood away? Move it farther.
  • Fog on the acrylic? Move the cable to the top.
  • Check the setup daily for the first week.

Products this guide covers

Super Reptile Heat Cable 3.5 mSuper Reptile Heat Cable 3.5 m

Still need help? Contact us

Email: canada.ant.colony@gmail.com
Call/text: 778-268-4576 · Owner: 437-213-9082
Français : 514-512-2017 · 中文 Chinese: 647-962-9560

More guides: all product instructions · ant care sheets · ant-keeping guides

← All product instructions

Back to blog

Ant Keeping Is For Everyone

If you're interested in supporting us, check out some of our ant farm kits!