Down The Ant Hill Outworld Instructions

← All product instructions

Clear acrylic outworld with an anti-escape ledge. This page has the same steps as the printed card that comes with your order, so you can find them again any time.

Size15 × 15 × 12 cm
Escape-proofHolds all species; no air vents to squeeze through

Setting up

  1. 1
    Unbox
    Lift off the rim and lid.
  2. 2
    Connect your nest
    Push a 12.7 mm vinyl tube into one of the holes and run it to your nest. For nests with a 9.5 mm port (like Esthetic Ants), slide the thinner tube into the 12.7 mm one. Seal a loose fit with hot glue or silicone.
  3. 3
    Plug unused holes
    Close any unused hole with cotton or a plug so ants can't escape.

Using your Down The Ant Hill outworld

  1. 4
    Add substrate (optional)
    A thin layer of sand or soil looks natural. To stop it shifting, set it with plaster of Paris or grout.
  2. 5
    Add heat (optional)
    Run a heat cable under one side, between the feet. Heating one side lets ants choose warm or cool.
  3. 6
    Clean safely
    Use only warm water and a soft cloth. Alcohol and solvents crack acrylic.

Good to know

  • Adjust to your ants: are your ants crowding the warm side? Move the heat closer; the cool side, farther.
  • Fluon, an anti-escape coating, is optional under the ledge.
  • This is your ants' “above-ground” area. Feed here, not in the nest.
  • Remove leftover food every day or two so it doesn't go mouldy.

Products this guide covers

Down The Ant Hill OutworldDown The Ant Hill Outworld

Still need help? Contact us

Email: canada.ant.colony@gmail.com
Call/text: 778-268-4576 · Owner: 437-213-9082
Français : 514-512-2017 · 中文 Chinese: 647-962-9560

More guides: all product instructions · ant care sheets · ant-keeping guides

← All product instructions

Volver al blog

La cría de hormigas es para todos

Si te interesa apoyarnos, ¡echa un vistazo a algunos de nuestros kits de hormigueros!