Feeding area for test tube colonies. This page has the same steps as the printed card that comes with your order, so you can find them again any time.
Size240 × 55 × 35 mm
Holds1–3 × 16 mm or 1–2 × 20 mm tubes
Setting up
-
1Fit the straw
Cut a 2 cm piece of a plastic or paper drink straw and push it under the cotton at the tube mouth. It forms a tunnel: ants come and go, the tube stays humid and the outworld stays dry (see the diagram below). -
2Seat the test tube
Lay the tube in an indent, straw end facing the open area. -
3Add heat
This outworld works best warm. Run the heat cable along one side of the outworld only, so ants can move to the cooler end. Our cable is very hot.
Using your test tube outworld
-
4Feed and clean
Feed away from the tube mouth; remove leftovers often. -
5Swap tubes easily
Water running low? Add a fresh tube; the colony moves over. -
6Do NOT add water
Keep the floor dry: damp hydrostone plus food waste grows mould.
How the straw keeps things dry
Good to know
- Adjust to your ants: crowding the warm side? Move the heat closer; the cool side, farther.
- Fluon (anti-escape coating) on the top walls is optional. Keep out of direct sun.
Products this guide covers
Still need help? Contact us
Email: canada.ant.colony@gmail.com
Call/text: 778-268-4576 · Owner: 437-213-9082
Français : 514-512-2017 · 中文 Chinese: 647-962-9560
More guides: all product instructions · ant care sheets · ant-keeping guides
